Info; Do I Need To Calibrate Manually - KARL DEUTSCH LEPTOSKOP 2042 Instruction Manual

10.5.14 Info

This info window shows specific information on your LEPTOSKOP 2042.
Menu topic
Device
S/N
Placings
Operating Hours XXX.XX
SW-Ver
Memory

11 Do I need to calibrate manually?

In addition to the default ex works calibration it is possible to calibrate manu-
ally if the measurement accuracy which can be obtained by means of the de-
fault ex works calibration
Checking for sufficient measurement accuracy:
You will need a reference sample, e.g.
a calibration foil and the uncoated substrate or a
permanent coating of known thickness on the material which will be used
for actual measurement (e.g. coating sample)
Measure the coating thickness of the reference sample and decide, whether
the measurement accuracy which can be obtained by the default ex works
calibration is sufficient for the application.
If the required measurement accuracy can not be obtained by means of the
default ex works calibration you can execute a manual calibration (see fol-
lowing sections). Further information on the calibration can be found in the
respective standards:
NFe probes:
DIN EN ISO 2360 for eddy current measurement.
Fe probes:
DIN EN ISO 2178 for measurement according to the magnetic-inductive
principle.
NFe/Fe combined probes: DIN EN ISO 2360 and DIN EN ISO 2178, de-
pending on the measuring method.
10
Reset of the instrument to default calibration: see section 12.2.8
Instruction Manual LEPTOSKOP 2042
Meaning
Distinct instrument type number
2042.001
Serial number
10000
Number of placings of the probe since delivery of the
XXXXX
instrument (contains measurements for final inspection
at the manufacturer's site)
Operating hours since delivery (contains operating
hours for final inspection at the manufacturer's site)
Included software version
XXXX
Internal information
xxxx xxxx
10
is not sufficient for the given application.
Art. No. 7423.421
31