Netvanta 3130 Rear Panel Design; Figure 7. Netvanta 3130 (With Dbu) Rear Panel Layout; Figure 8. Netvanta 3130 (Without Dbu) Rear Panel Layout - ADTRAN NetVanta 3458-PoE Hardware Installation Manual

NetVanta 3000 Series Hardware Installation Guide

NetVanta 3130 Rear Panel Design

The NetVanta 3130 rear panel is shown below.
ADSL
Default
Switch
ADSL
Default
Switch

Figure 8. NetVanta 3130 (without DBU) Rear Panel Layout

NetVanta 3130 Rear Panel Interfaces
ADSL Interface
The NetVanta 3130 rear panel has an
service.
DBU Interface (1700610L2 only)
The NetVanta 3130 has a
Factory Default Switch
The NetVanta 3130 has a factory default switch (labeled in
factory default switch is pressed during bootup, the unit will stay in bootstrap mode. Since the unit has
no serial port, Telnet has been built into the boot code. The default IP address is 10.10.10.1.
The default switch must be pressed WHILE the STAT light is flashing green. Do not
press the default switch BEFORE the STAT light is flashing green, as this will cause
boot to be missed.
61200860L1-34AA
DBU

Figure 7. NetVanta 3130 (with DBU) Rear Panel Layout

1
ADSL
DBU port on the rear panel to provide analog, V.90 dial backup.
Copyright © 2010 ADTRAN, Inc.
Appendix A on page 101
1 2 3 4
2 3 4
port to connect directly to ADSL, ADSL2, or ADSL2+
Figure
Physical Descriptions
provides pinouts.
1 0
1 0
7) on the rear of the unit. If the
23