3.25 Charging; 3.26 Joystick Stationary Time Exceeded; 3.27 Orientation Error; 3.28 Asm Disconnected - Magic Mobility R-NET CJSM2 User Manual

r-net user guide
An entry is made in the system log each time this occurs.

3.25 Charging

This occurs when the control system detects that a charger is connected to either Inhibit 1 or Inhibit 3.
The Battery charging screen will be displayed during charger connection.
An entry is made in the system log each time this occurs.
If an On-Board Charger is used:
Disconnect the charger from the AC supply.
If an Off-Board Charger is used:
Disconnect the charger from the Wheelchair.
If the trip is still present after the charger has been disconnected, then the Joystick Module may be defective.
Refer to Section 5.

3.26 Joystick stationary time exceeded

This occurs when the joystick is deemed to have been held stationary for an excessive period of time. The
controller will stop drive to prevent possible damage the wheelchair's motors.
Turning the control system Off and On again will clear this error message.
If the trip is still present after the power has been cycled, then the R-Net control system may be defective.
Refer to Section 5.

3.27 Orientation error

This error occurs when the programmed orientation of the ASM does not match the actual mounted
orientation.
Check the programming of the parameter Orientation against the actual mounting of the ASM.
If the trip is still present after the above checks have been made, then the ASM may be defective. Refer to
Section 5.

3.28 ASM disconnected

This error occurs when the control system detects an error with the ASM or the ASM becomes disconnected.
Check the motors, cables and connections to the control system.
If the trip is still present after the above checks have been made, then the ASM may be defective. Refer to
Section 5.

3.29 Switch short

This occurs when the CJSM2 has detected that either of the External Switch Jack Sockets has a short-circuit.
The actual Switch that has the short-circuit is indicated by the Trip Code. The code is in Hex.
1E0D: External On/Off Switch jack socket.
1E0C: External Profile/Mode Switch jack socket
Check the operation of the switch and all cables and connectors between the CJSM2 and the identified
switch.
43
5940A R-net User Guide DCR1266 magicmobility.com.au