Magic Mobility R-NET CJSM2 User Manual page 13

r-net user guide
5.1.2 SPEED INDICATOR
5.1.3 CURRENT PROFILE
5.1.4 FOCUS
5.1.5 SPEED LIMIT
5.1.6 LATCHED
5.1.7 RESTART
5.1.8 FAULT
5.1.9 MOTOR TEMPERATURE
13
5940A R-net User Guide DCR1266
This displays the current speed setting.
The speed setting is adjusted using the Speed Buttons.
The Profile Number describes which Profile the control system is currently
operating in.
The Profile Text is the name or description of the Profile the control system is
currently operating in.
When the control system contains more than one method of direct control, such
as a secondary Joystick Module or a Dual Attendant Module, then the Module
that has control of the wheelchair will display the In Focus symbol.
If the speed of the wheelchair is being limited, for example by a raised seat, then
this symbol will be displayed.
If the wheelchair is being inhibited from driving, then the symbol will flash.
When the control system is operating in a latched condition this symbol will be
displayed.
When the control system requires a reboot; for example, after a module re-
configuration, this symbol will be flashed.
The control system can detect a wide variety of errors. When the system has
detected an error that is not severe enough to cause the system to trip, then this
symbol will be displayed.
This symbol is displayed when the control system has intentionally reduced the
power to the motors, in order to protect them against heat damage.
magicmobility.com.au