Run - Paragon EL71 General Instructions Manual

RUN

The RUN mode is the normal operating mode. In the RUN mode the current time and day
are shown. If today is a holiday, the active holiday schedule is also shown. Channel status
is shown on the bottom line. The channel number is shown if that channel is on. If the
channel number is flashing, that channel is currently overridden. If it is flashing mostly on,
the channel is overridden on. If it is flashing mostly off, the channel is overridden off. The
input # is also shown along with the status of that input. The following is a list of the possi-
ble input status messages:
Message
NONE
On\d
OFFd
-N-
OVd
-V-
ENb
dISb
072F
LO F
025C
HI C
055L
175U
Input Config. Status
not config --
On\d input closed
On\d input open, in delay
On\d not active
OVR overridden on w/delay?
OVR not active or overridden on or off without delay
ENb input closed (enabled)
ENb input open (disabled)
sensor, F sensor value
sensor, F sensor value below range
sensor, C sensor value
sensor, C sensor value above range
sensor, L sensor value
sensor, U sensor value
33