Restoring Settings From A Backup; Restoring Settings To Factory Defaults; Sending Device Logs To A Syslog Server - 3Com 3CRGPC10075 User Manual

88 C 5: P
HAPTER ERFORMING
Restoring Settings
from a Backup
Restoring Settings to
Factory Defaults
Sending Device
Logs to a Syslog
Server
A A
DDITIONAL DMINISTRATIVE
To restore settings from a backup file:
1 On the Config File screen, click Browse under Restore. The Choose file
dialog box appears.
2 Click the backup file, and then click Open.
3 Click Restore. A warning message appears.
Restoring settings from a backup will erase all the current settings.
4 Click OK.
The Access Point reads the backup file, writes the settings to memory,
and then restarts itself.
To erase the current settings and restore the original factory default
settings, click Set to Defaults on the Config File screen.
Restoring settings to factory defaults all the current settings.
Resetting to default requires the Access Point to restart itself. The device
will terminate your connection to the Web interface when it restarts.
By default, the Access Point acts as a DHCP client. If there is a DHCP
server on the network, the device will automatically obtain an IP address
from it. The new IP address will most likely be different from the old one.
Use the 3Com Access Point Manager to determine the new IP address.
If you have a syslog server on the network, you can configure the Access
Point to send the device logs to the server.
To send the device logs to a syslog server:
1 On the menu, click Management.
2 Click the Log Settings tab.
3 Click one of the following options:
Broadcast – Broadcasts the device logs. Click this option if different
■
computers function as the syslog server at different times.
Send to <IP address> – Sends the device logs to a particular server.
■
Click this option if only one computer is configured as the syslog
server on the network.
T
ASKS