Without A Dhcp Server - 3Com 3CRGPC10075 User Manual

26 C 2: I
HAPTER NSTALLING AND
Without a DHCP
Server
C A
ONNECTING THE
6 Click OK.
If you do not have a DHCP server on the network, you need to
reconfigure the TCP/IP settings of the admin computer to be able to
connect to the Access Point's Web interface.
1 Open the Properties dialog box of the network interface card that the
computer is using to connect to the wired local network.
2 Click Internet Protocol, and then click Properties.
3 On the General tab, click Use the following IP address.
4 Assign an IP address and a subnet mask to the computer.
In IP address, type any IP address within the range of 192.168.0.1 to
■
192.168.0.255, except 192.168.0.228.
In Subnet mask, ensure that it is set to 255.255.255.0.
■
5 Click OK.
6 Start your Web browser.
7 In the Address or Location bar, type
authentication dialog box appears.
8 In User name, type
User name and password are case-sensitive.
9 Click OK.
The interface loads in your Web browser.
P
CCESS OINT
http://192.168.0.228
, and in Password, type
admin
. An
.
password