Restoring The Bridge To Factory Defaults - 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge User Manual

Restoring the Bridge
to Factory Defaults
Downloaded from www.Manualslib.com
You can restore Bridge settings to the defaults that were set at the
factory either manually or through software.
To restore the settings manually, insert a pointed object (such as the end
of a straightened paper clip) into the reset hole on the back of the Bridge,
and hold for five seconds.
The reset hole is accessible with the Bridge in the cradle, as shown in
Figure 16, or with the Bridge out of the cradle.
Figure 16 Manually Resetting the Bridge in the Cradle
To restore the settings through software:
1 Under Tools, click Restore Factory Defaults.
2 Click Restore.
If the Bridge was using an IP address setting other than the default,
restoring the factory defaults will change the IP address. If you want to
continue configuring the Bridge, do the following:
1 Close your browser.
2 Return to the 3Com Wireless Infrastructure Device Manager and click Refresh.
3 Select the device and click Configure to start a new configuration session.
manuals search engine
Using the Configuration Management System
Reset Hole
RESET
RESET
43