Snmp-Server Enable Server; Snmp-Server Host - 3Com 3CRWE876075 User Manual

snmp-server enable server

This command enables SNMP management access and also enables this device to
send SNMP traps (i.e., notifications). Use the no form to disable SNMP service and
trap messages.
Syntax
snmp-server enable server
no snmp-server enable server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• This command enables both authentication failure notifications and
link-up-down notifications.
• The snmp-server host command specifies the host device that will
receive SNMP notifications.
Example
Enterprise AP(config)#snmp-server enable server
Enterprise AP(config)#
Related Commands

snmp-server host (5-47)

snmp-server host
This command specifies the recipient of an SNMP notification. Use the no form to
remove the specified host.
Syntax
snmp-server host <1 | 2 | 3 | 4> <host_ip_address | host_name>
<community-string>
no snmp-server host
• 1 - First SNMP host.
• 2 - Second SNMP host.
• 3 - Third SNMP host.
• 4 - Fourth SNMP host.
• host_ip_address - IP of the host (the targeted recipient).
5-47
Using the Command Line Interface