Can Enable Switch (Sw2); Uart Enable Switch (Sw4) - Analog Devices EZ-KIT Lite ADSP-BF538F System Manual

Jumper and Switch Settings

CAN Enable Switch (SW2)

The Controller Area Network (CAN) enable switch (
CAN signals from the GPIO pins of the processor. When the
in the position, the associated GPIO signals (see
OFF
used on the expansion interface.
Table 2-3. CAN Enable Switch (SW2)
CAN Signal
ENABLE
STANDBY
ERROR
RECEIVE DATA

UART Enable Switch (SW4)

The UART enable switch (
pins of the processor. When the switch is in the
ated GPIO signals (see
Table 2-4. UART Enable Switch (SW4)
EZ-KIT Lite Signal
CTS
RX0
RTS
LOOPBACK
2-10
SW2 Switch Position (Default)
1 ( )
ON
2 ( )
ON
3 ( )
ON
4 ( )
ON
) disconnects UART signals from the GPIO
SW4
Table 2-4) can be used on the expansion interface.
SW4 Switch Position (Default)
1 ( )
ON
2 ( )
ON
3 ( )
ON
4 ( )
OFF
ADSP-BF538F EZ-KIT Lite Evaluation System Manual
) disconnects
SW2
SW2
Table 2-3) can be
Processor Signal
NU
NU
PD9
PC1
position, the associ-
OFF
Processor Signal
PC0
NU
PC1
NU
switch is