Advertisement
IN100 Cylindrical Lock
Lock Self-Test LED indication
After replacing batteries, a Power on Self Test (POST) is performed. The result is indicated using
a series of red and green LED flashes as described by the figures below.
LED indication after power up/replacement of the battery
8.3.1
Battery not fully charged
Error in lock is an indication -10 quick (125ms) red blinks, that either new batteries are not at the
right voltage or a backward battery has been installed; battery not fully charged; energy counter
not reset or no Power on self-test done.
maintenance required
8.3.2
Test pass
1 red (1s) + 1 green (1s), Power on self-test passed, see table below.
Figure 6. Lock POST LED
indication
8.3.3
Test fail
1 red (1s) + 3 blinks (.5 sec, green or red), at least one test failed (red), see table below.
If a fatal error is detected the lock will enter an Error state and continuously indicating fatal error and will
not read cards nor unlock.
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
Error in lock,
POST Successful
FATAL ERROR
CABLE ERROR
MECHANICAL ERROR
FATAL ERROR
Tests core functionality - MCUs, memory and internal
communication, etc.
CABLE ERROR
Tests communication between the different
parts in the system, i.e. different boards
connected with a wire.
MECHANICAL ERROR
Test related to moving parts of the lock.
Ten red flashes (.125 sec. each)
(Repeated every 10 sec. if lock can't close)
One red, one green flash
(1 second)
1 sec
0.5 sec
0.5 sec
19
0.5 sec
Advertisement
