Unit Status
This page provides detailed information about the
unit:
System Name The name configured for the switch.
Contact The person to contact if there is a problem
with the network.
Location Where the switch is located.
The Unit Name, Location and Contact can be
configured using pages in the Management Settings
category.
Hardware Version The version of hardware inside
the switch.
MAC Address The switch's MAC (Ethernet) address.
Software Version The version of management
software that the switch is running.
Boot PROM Version The version of software on the
Boot PROM inside the switch.
System Uptime The time that has elapsed since the
switch was last reset, initialized or powered on.
To display the Management Addresses page, click
IP Setup at the bottom of the Unit Status page.
Management Addresses
This page specifies a unique IP address for the
switch, as shown in
IP configured correctly if you want to manage it over
the network.
If you have no previous knowledge of IP, refer to
Appendix
B. If you change any of these values, you
must reset the switch (refer to
and then re-access the switch using the new values.
Figure 4-8
Management Addresses Page
Unit Pages
Figure
4-8. The switch must have
"Reset"
on page 4-24)
4-11