Restarting The Actuator (Reset); Reset To Default Settings; Testing The Display - Samson 3374 Series Mounting And Operating Instructions

Operation
Î Initialization can be canceled at all times by selecting ESC.
8.4.3

Restarting the actuator (reset)

The actuator can be restarted by performing a reset. Upon restart, the actuator goes into the
operating mode previously set unless a different restart condition has been defined (see the
'Start-up and configuration' section).
Code Description
d53 Perform reset
8.4.4

Reset to default settings

All the parameters of the configuration level can be reset to their default settings (WE).
Code Description
d54 Load default settings in actuator
8.4.5

Testing the display

All the segments of the display are shown during the display test when a display functions
properly. The display test is performed by selecting Code d55 in the service level (Code 20).
Code Description
d55 Testing the display
Activate display test (service level/Code 20)
1. Turn (when the start screen appears) to select Code d55
(display: TEST).
2. Press to start test.
Î All segments are shown.
3. Press to hide all segments (backlight remains switched on)
4. Press again to return to the d55 TEST reading.
8-10
Adjustment range
RES
Adjustment range
DEF
Adjustment range
TEST (all segments displayed)
S
mm
%
EB 8331-4 EN