Multisound Mode; Section 1 . About Each Of The Functions - Korg DSS-1 Owner's Manual

MULTISOUND MODE

1 .About Each of the
FO GET SOUNDS
About the get sounds function
1
■ This is used to get sounds from disk to wave memory
and assign them to the keyboard (starting at the
lower part of the keyboard with sound number 01 and
working up) to create a multisound.
■ Before getting any sounds, you are asked if you want
the loop on or off. If the sounds that you will get are
single full wave cycles, then please answer Y E S to
turn the loop on.
■ Sound assignments must start with the lowest range
of the keyboard that you will use. You cannot later
change the order of the assigned sounds.
■ Wave memory is used as the work area for creating
multisounds. The completed multisound appears as
M U LTI S O U N D No. 1 in the "system " resident in the
D S S -1 .
(Multisounds previously present in the DSS-1 resi­
dent system are all lost.)
■ The G E T S O U N D function is cancelled If the number
of sounds in the multisound under construction ex­
ceeds 16, or if the sum of the sound lengths comes to
equal the size of wave memory (262,886).
■ You can control the length of the sound loaded from
disk by setting its LO A D LENGTH.
Functions
Example: Trying to get sound number 04 after yetting sound number 03.
Acceptable load length range.
1471