X50 Test Mode; How To Enter The Test Mode; How To Operate In The Test Mode - Korg X50 Service Manual

X50 TEST MODE

How to enter the TEST MODE

[MENU/OK] + [PROGRAM A] & POWER ON:
[MENU/OK] + [PROGRAM B] & POWER ON:
[MENU/OK] + [PROGRAM D] & POWER ON:
[EXIT/CANCEL] + [PAGE+] & POWER ON:
[EXIT/CANCEL] + [MENU/OK] & POWER ON:
[EXIT/CANCEL] + [PAGE-] & POWER ON:

How To Operate in the TEST MODE

[ENTER]: Proceed the test
[PAGE +]: Proceed the test item
[PAGE -]: Return to the former test item
CLICKABLE POINTER →: Proceed the step
CLICKABLE POINTER ←: Return to the former step
[AUDITION]:
[SELECT]:
[MENU/OK]:
[EXIT/CANCEL]:
CAUTION
*During the inspection, you can adjust the contrast by rotating the ENCODER.
But rotating the ENCODER too fast causes that you cannot read the display sometime.
Because the software gives the priority to the internal processing than display.
*X50 needs the calibration of WHEEL, so after repairing do the calibration of the JOYSTICK.
When an error happened in the FULL inspection, you can proceed to the next inspection by pushing
[MENU/OK].
FULL INSPECTION
INSPECTION WITHOUT INTERNAL TEST
INSPECTION WITHOUT MIDI/USB
INITIALIZE OF MEMORY
Loading the Preload Data
Display of the Version (Right bottom of the Initial
Screen)
ENCORDER RESET
MEMORY REPORT
YES (OK)
NO (CANCEL)