Optical Interface O1 - Walther Systemtechnik WLVCM Operating Manual

6.2.2 Optical Interface O1

The O1 optical interface comes with a total of eight light diodes (se also figure xyz); they indicate the
system statuses of the WLVCM:
LED Name
1 Error temperature
2 Error current limitation
3 Ready for start
Shot/shot sequence
4
active
Shot/shot sequence
5
finished
6 +24V
7 Operating status
8 Input start
Operating Manual WLVCM-BA-10
Value Specification
ON Temperature not within tolerance range
OFF Temperature within tolerance range
ON Authorized current for clamp "Valve +" exceeded
OFF Current at clamp "Valve +" below limit value
ON WLVCM ready for operation
OFF WLVCM not ready for operation
ON Currently an application is carried out
OFF No application active
ON Application finished
OFF Application not finished
ON Operating voltage 24VDC available
OFF No / wrong operating voltage available
Active date transfer between WLVCM and configuration
ON
tool
No active data transfer between WLVCM and
OFF
configuration tool
ON Start signal applied (clamps „Start –„ and „Start +")
OFF Start signal not applied
Table 9 – Light diodes of the optical interface O1 and their relevance
EN
Page 19 of 37