Dual Enclosure Flying Plate Set - Pioneer XY Series Installation Manual

3 Rigging And Caster Setting
__________________________________________________________________________________________________________

3.2.4 Dual Enclosure Flying Plate Set

When using the Dual Enclosure Flying Plate Set, multiple enclosures
can be stably combined side by side and suspended from the ceiling as
shown in the figure below.
Table.3-2-4-A: Models compatible with Dual Enclosure Flying Plate Set
and inclined angle between the 2 enclosures
Only for CP-XY1DF1
When using the CP-XY1DF1 to combine XY-1/XY-2E, the direction of the speaker can be selected from the
following two settings, depending on the purpose.
A. By aligning the front of the speakers, XY-1 and XY-2E
can be handled like a single full range speaker.
WARNING:
- Do not attempt to use this product with components other than the specified speaker.
- Be sure to use the supplied accessory screws.
- Flat washer and spring washer out of the reach of children and infants. If acidentally swallowed, contact a
doctor immediately.
- After mounting the speaker with the cradle, never loosen any of its accessory installation screws, since
the speaker could fall or other accidents could occur.
- Attach a wire to a rigging point different from those for installing the cradle to prevent swaying.
- Dual Enclosure Flying Plate Set is not supposed to be used in the following situations, which may cause
an injury or accident.
Connecting 4 or
more units horizontally
http://pioneerproaudio.com/
B. XY-2E can be connected at an angle to reduce
sound interference between the two loudspeakers.
Prohibition of
suspending only at
balancing points
NOTE: XY-3Bs are shown in the illustration.
©2020 AlphaTheta CORPORATION
Page 22 / 43