Procedures; Xy-2 - Pioneer XY Series Installation Manual

3 Rigging And Caster Setting
__________________________________________________________________________________________________________

3.2 Procedures

3.2.1 XY-2

Using the included yoke, suspension of the XY-2 from the ceiling, wall,
and bottom of XY-3B/XY-1/XY-2E is available.
The orientation of the enclosure can be changed at any angle.
Several holes on both sides of the outer yoke of the cradle are used to
change the length of the outer yoke so that the distance between the
enclosure and the cradle can be adjusted. The factory default sets the
distance between the enclosure and the cradle at the nearest position.
If you want to connect a speaker cable and incline the enclosure,
please select a different hole on the outer yoke to enlarge the distance.
Table.3-2-2-A: Installation to the ceiling and wall
WARNING:
- Be careful not to insert your fingers between the steel arms when you adjust the angle of them.
- XY-2 is not supposed to be used in the following situations, which may cause an injury or accident.
For ALL the models, the following situations are quite dangerous.
Suspending from sloped
(non-horizontal) ceiling
Part list (XY-2)
Item Part Name
1 Main Yoke
2 Yoke mount
3 Flat Washer
4 Spring Washer
5 M10 socket head bolt
6 M10 Special bolt
7 Spring Washer
8 Flat washer
http://pioneerproaudio.com/
Excluding installation,
levers/handles/bolts.
Qty Service Part No. Note
1 -
2 -
2 06D014 M10
2 06D015 M10
M10 x 40mm (P=1.5),
-
2 8mm hex socket head
M10 x 41mm (P=1.5),
1 - 6mm hex socket head
shoulder bolt
1 - M12
1 - M12
The outer yoke of
the cradle is not
loosing the side
horizontal to the wall
©2020 AlphaTheta CORPORATION
Required tools
・6mm hex key
・8mm hex key
Page 10 / 43