Pioneer XY Series Installation Manual page 19

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Part list (CP-XY3DF1)
Item Part Name
1 Dual Enclosure Flying Plate
2 Rear Plate Top
3 Rear Plate Bottom
4 M10 socket head bolt
5 Spring washer
6 Flat washer
Part list (CP-XY1DF1)
Item Part Name
1 Dual Enclosure Flying Plate
2 Rear Plate
4 M10 socket head bolt
5 Spring washer
6 Flat washer
Procedure (CP-XY3DF1 / CP-XY1DF1 as Variable angle bracket)
(0) Only For CP-XY1DF1
Remove the four blindfold screws on the top surface of XY-1/XY-2E.
(Fig.3-2-3-B)
(1) Using the supplied M10 socket head bolts(B), align the mounting
holes in the Dual Flying Plate(A) with the mounting points on the top
of the enclosure.
Ensure that both the Spring washers(C) and Flat washers(D) are
used - the Flat washer(D) should be in contact with the bracket.
Tighten the bolts at 15N·m torque. (Fig.3-2-3-B)
http://pioneerproaudio.com/
Service
Qty Note
Part No.
1 -
1 10B917L Disuse
1 10B917S Disuse
M10 x 20mm (P=1.5),
9 06B522 8mm hex socket head
Included spare: 5
9 06D015 M10, Included spare: 5
9 06D014 M10, Included spare: 5
Service
Qty Note
Part No.
1 -
1 - Disuse
M10 x 40 mm (P=1.5),
7 - 8mm hex socket head
Included spare: 3
7 - M10, Included spare: 3
7 - M10, Included spare: 3
Required tools
- 8mm hex key
NOTE: XY-1 is shown in the illustration.
Fig.3-2-3-A
(B)
(C)
(D)
Fig.3-2-3-B
©2020 AlphaTheta CORPORATION
(A)
Page 19 / 43