Pioneer XY Series Installation Manual page 30

3 Rigging And Caster Setting
___________________________________________________________________________________________________________
3.2.5 Suspension of the enclosure using the eyebolt
The speaker has the mounting points where commercially-available eyebolts can be mounted. Using the
commercially-available eyebolts, a speaker or a combination of them can be vertically suspended.
WARNING:
Specification of eyebolt
- If you use any commercially available eyebolt, ensure it is the same size as in the list below and
have enough strength to withstand the weight of the loudspeaker.
Table.3-2-5-A: Specification of eyebolt for each model
NOTE only for XY-3B:
The nuts of the threaded fixing points on XY-3B are
structured so that bolts cannot pass through them. (max
threaded length is 15mm.)
Adjusting the direction of eyebolt
Screw the eye bolts into the nuts so that they are engaged
within the range of 10 to 15 mm (0.39 to 0.59 in.) and then
tighten the nuts with a spanner while matching the direction
of the eye bolts to fix them in place.
Limits of combining multiple speakers
- Be sure to meet the conditions and requirements shown in the Table.3-2-5-B.
Table.3-2-5-B: Limits and requirements of combining multiple speakers using eyebolts
Eyebolt is not supposed to be used in the following situations, which may cause an injury or accident.
For all the models, the following situations are quite dangerous.
For all models :
Over 120 kg
http://pioneerproaudio.com/
Suspending horizontally
using eyebolts
NOTE: XY-3B is shown in the illustration.
Only for the following model : XY-3B
Suspending using XY-2
mounting holes at bottom
Suspending
multiple enclosures
Page 30 / 43
©2020 AlphaTheta CORPORATION