Pioneer XY Series Installation Manual page 15

Hide thumbs Also See for XY Series:

Table of Contents

3 Rigging And Caster Setting

_________________________________________________________________________________________________________

When the yoke is attached to the speaker first

(A)

Using the supplied four M10 socket head bolts (G), align the

(3a)

main mounting holes and the hole for angle adjustment in the

yoke (F) with the mounting points on the side plate. Ensure that

both the Flat Washer (H) and the Spring Washer (I) are used -

the Flat Washer (H) should be in contact with the cradle.

Tighten the bolts over 15 N·m torque. (Fig.3-2-2-C)

Install the speakers to the ceiling and loosen the angle

(4a)

adjustment screws to adjust the direction of the speakers. Once

the speaker angle is set, retighten the screws. (Fig.3-2-2-D)

Please read section (8) as your next task.

2 When the yoke is attached to the ceiling first and then the

(B)

speaker is attached to the yoke

(3b)

Attach the yoke to the ceiling. (Fig.3-2-2-E)

http://pioneerproaudio.com/

(F)

(H) (I)

Fig.3-2-2-C

NOTE: XY-1 is shown in the illustration.

1 x φ13

1 x

Fig.3-2-2-E

(G)

Fig.3-2-2-D

(F)

Page 15 / 43

Table of Contents

Xy-3b Xy-1 Xy-2 Xy-2e