Pioneer XY Series Installation Manual page 25

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Note:
- For larger down-tilt angles, position the pivot on the last hole and
use the point on the rear or underside as a pull-back.
- XY-2 can be attached to the bottom of each enclosure.
WARNING:
- Attach two or more wire to a rigging point different from those for
installing the cluster to prevent swaying. (Fig.3-2-4-D)
- When attaching the XY-2 to the XY-3B/XY-1/XY-2E, do not attach
it to anywhere other than the bottom of the speaker. Make sure to
use the included bolt, washer, and spring washer.
- Do not suspend anything other than an XY-2 to the bottom of the
XY-3B/XY-1/XY-2E. Also, do not suspend two or more XY-2s to
each of the enclosure.
Ensure the two commercially-available eyebolt are secured to
(4)
mounting point on the top of each enclosure to suspend it with wire
as a secondary safety feature. (Fig.3-2-4-E)
For preventing to occur the noise from secondary safety wires,
wire length should be as short as possible.
http://pioneerproaudio.com/
-available wire
Commercially
-available
eyebolt
©2020 AlphaTheta CORPORATION
Commercially
Fig.3-2-4-D
Commercially
-available
eyebolt
Fig.3-2-4-E
Page 25 / 43