Pioneer XY Series Installation Manual page 29

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Holes on the top plate can be used to install the speaker to the
(6)
ceiling. (Fig.3-2-4-L)
Note: Only CP-XY1VC1
When using the CP-XY1DF1 to connect different left and right
speakers, a wire can be attached to the balancing point and pulled
to keep the weight balanced.
However, do not take down the speaker at the balancing point
Note:
- For larger down-tilt angles, position the pivot on the last hole and
use the point on the rear or underside as a pull-back.
- XY-2 can be attached to the bottom of each enclosure.
WARNING:
- Attach two or more wire to a rigging point different from those for
installing the cluster to prevent swaying. (Fig.3-2-3-M)
- When attaching the XY-2 to the XY-3B/XY-1/XY-2E, do not attach
it to anywhere other than the bottom of the speaker. Make sure to
use the included bolt, washer, and spring washer.
- Do not suspend anything other than an XY-2 to the bottom of the
XY-3B/XY-1/XY-2E. Also, do not suspend two or more XY-2s to
each of the enclosure.
Ensure the two or more commercially-available eyebolt are
(4)
secured to mounting point on the top of each enclosure to suspend
it with wire as a secondary safety feature. (Fig.3-2-4-N)
For preventing to occur the noise from secondary safety wires,
wire length should be as short as possible.
http://pioneerproaudio.com/
Fig.3-2-4-L
Commercially
-available wire
Commercially
-available
eyebolt
©2020 AlphaTheta CORPORATION
To the ceiling
Balancing point
Fig.3-2-4-M
Commercially
-available
Fig.3-2-4-N
Page 29 / 43