Pioneer XY Series Installation Manual page 16

3 Rigging And Caster Setting
_________________________________________________________________________________________________________
Attach the two socket head bolt (G) to the temporary fixing
(4b)
points on the side plate. Insert the bolts into the side plate by
about 10 mm.
There is no need to install the Flat washer and Spring washer
with the bolts. (Fig.3-2-2-F)
Lift the speaker up to the ceiling and insert the temporary fixing bolts on the side of the speaker into the
(5b)
temporary fixing slits in the yoke. (Fig.3-2-2-G)
Once the speaker is attached to the yoke, securely fasten the yoke fixing bolt and angle adjustment socket head
(6b)
bolt. (Fig.3-2-2-H)
After that, remove the temporary fixing bolts. (Fig.3-2-2-I)
Fig.3-2-2-H
http://pioneerproaudio.com/
Fig.3-2-2-F
NOTE: XY-1 is shown in the illustration.
Fig.3-2-2-G
(H) (I)
(G)
(F)
Fig.3-2-2-I
Page 16 / 43
©2020 AlphaTheta CORPORATION
(G)
(G)