Pioneer XY Series Installation Manual page 24

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Refer to the instructions below to install a rear plate on the back of
each speaker.
CP-XY1DF1
Using the supplied M10 socket head bolts(B), align the mounting
holes on the Rear plate bottom(F) with the mounting points of the
rear of the enclosures. Ensure that both the Spring washer(C) and
Flat washer(D) are used in between the rear plate (F) and the M10
socket head bolt(B). Tighten the bolts at 15N·m torque. (Fig.3-2-4-
C)
WARNING:
- When assembling cluster using the CP-XY1DF1, back of the
enclosures must be fixed using a rear plates.
CP-XY3DF1
Using the supplied M10 socket head bolts(B), align the mounting
holes on the Rear plate top(E) and Rear plate bottom(F) with the
mounting points of the rear of the enclosures. Ensure that both the
Spring washer(C) and Flat washer(D) are used in between the rear
plates(E/F) and the M10 socket head bolt(B). Tighten the bolts at
15N·m torque. (Fig.3-2-4-C)
WARNING:
- When assembling cluster using the CP-XY3DF1, back of the
enclosures must be fixed using a set of two rear plates.
Holes on the top plate can be used to install the speaker to the
(3)
ceiling. (Fig.3-2-4-D)
Note: Only CP-XY1DF1
When using the CP-XY1DF1 to connect different left and right
speakers, a wire can be attached to the balancing point and pulled
to keep the weight balanced.
However, do not take down the speaker at the balancing point
The range of inclined angle when a CP-XY3DF1 is used to
suspend the speaker from the ceiling is shown in the table below:
The mounting point 1
Only XY-3B 20
Angle
[°]
XY-3B + XY-2 16
Front
http://pioneerproaudio.com/
2 3 4 5 6
18 14 11 8 5
14 11 9 7 4
(B)
Rear plate top (E) is
Fig.3-2-4-C
7 8 9 10 11 12
2 -1 -5 -8 -11 -14
2 -1 -3 -6 -8 -11
(D)
(C)
(E)
(F)
To the ceiling
Balancing point
(Only for CP-XY1VC1)
Fig.3-2-4-D
13 14 15 16
-17 -20 -23 -25
-13 -15 -18 -20
Page 24 / 43
©2020 AlphaTheta CORPORATION
Back