Pioneer XY Series Installation Manual page 23

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Part list (CP-XY3DF1)
Item Part Name
1 Vertical connection plate
2 M10 countersunk bolt
3 Rubber pad
Part list (CP-XY1DF1)
Item Part Name
1 Dual Enclosure Flying Plate
2 Rear Plate
3 M10 socket head bolt
4 Spring washer
5 Flat washer
Procedure (CP-XY3DF1 / CP-XY1DF1)
(0) Only For CP-XY1DF1
Remove the two screws on the top surface of XY-1/XY-2E from the
side where the speaker contacts. (Fig.3-2-4-A)
(1) Using the supplied M10 socket head bolts(B), align the mounting
holes on the Dual enclosure flying plate(A) with the mounting
points of the top of the enclosure. Ensure that both the Spring
washer(C) and Flat washer(D) are used in between the Dual
enclosure flying plate(A) and the M10 socket head bolt(B). Tighten
the bolts at 15N·m torque. (Fig.3-2-4-B)
WARNING:
- The top of each enclosure must be fixed with the proper
mounting holes on top plate(A) as following figure.
CP-XY3DF1
CP-XY1DF1
1. Frontal alignment
http://pioneerproaudio.com/
Service
Qty Note
Part No.
4 - -
M10 x 35 mm (P=1.5),
9 - 6 mm hex socket head,
Included spare:1
5 - -
Service
Qty Note
Part No.
1 - -
1 - -
M10 x 40 mm (P=1.5),
7 - 8mm hex socket head,
Included spare:1
7 - M10, Included spare:1
7 - M10, Included spare:1
2. Horizontal coverage extension
Required tools
・8mm hex key
NOTE: XY-2E is shown in the illustration.
Fig.3-2-4-A
(B)
(C)
(D)
Fig.3-2-4-B
©2020 AlphaTheta CORPORATION
(A)
Page 23 / 43