Pioneer XY Series Installation Manual page 28

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
(2)
Remove the blindfold screws on the sides of XY-1/XY-2E, and use
Countersunk bolts to secure the vertical connection plate to the
speaker and connect the upper and lower speakers together.
Tighten the bolts at 15N·m torque. (Fig.3-2-4-I)
Secure each stack connected by CP-XY1CON1 with the top plate
(4)
of CP-XY1DF1. Tighten the bolts at 15N·m torque. (Fig.3-2-4-I)
(5) Using the supplied M10 socket head bolts(B), align the mounting
holes on the Rear plate (F) with the mounting points of the rear of
the enclosures. Ensure that both the Spring washer(C) and Flat
washer(D) are used in between the rear plates(F) and the M10
socket head bolt(B). Tighten the bolts at 15N·m torque. (Fig.3-2-4-
K)
WARNING:
- When assembling cluster using the CP-XY1DF1, back of the
enclosures must be fixed using a rear plates.
http://pioneerproaudio.com/
Fig.3-2-4-I
(B)
(C)
(D)
(D)
(C)
(B)
Fig.3-2-4-K
©2020 AlphaTheta CORPORATION
(A)
Fig.3-2-4-J
(F)
Page 28 / 43