Pioneer XY Series Installation Manual page 26

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Assembling the cluster using Dual enclosure flying plate and Vertical connection plate
By using the dual enclosure flying plate and vertical connection plate,
XY-1/XY-2E can be connected horizontally and vertically to assemble a
cluster.
NOTE: All the parts for a combination of Dual Enclosure Flying
Plate Set and Vertical connection plate set should be compatible
with respective speakers, XY-1 and XY-2E.
Maximum number of connections
The maximum number of these connections is 3 horizontally and 3
vertically. An XY-2 can also be connected underneath it. (Fig.3-2-4-F)
WARNING:
- Do not attempt to use this product with components other than the specified speaker.
- Be sure to use the supplied accessory screws.
- Flat washer and spring washer out of the reach of children and infants. If acidentally swallowed, contact a
doctor immediately.
- After mounting the speaker with the cradle, never loosen any of its accessory installation screws, since
the speaker could fall or other accidents could occur.
- Attach two or more wires to a rigging point different from those for installing the cradle to prevent swaying.
- The Variable Angle Bracket and the Dual Enclosure Flying Plate Set are not supposed to be used in the
following situations, which may cause an injury or accident.
Connecting 4 or
more units horizontally
http://pioneerproaudio.com/
Fig.3-2-4-F
Connecting 4 or
more units vertically
Page 26 / 43
©2020 AlphaTheta CORPORATION