Vertical Flying Cradle - Pioneer XY Series Installation Manual

3 Rigging And Caster Setting
_________________________________________________________________________________________________________

3.2.2 Vertical Flying Cradle

When using the Vertical Flying Cradle, suspension of the XY-1 and
XY-2E enclosure vertically from the ceiling as shown in the right figure
is available. Speaker models compatible with respective Vertical Flying
Cradles are shown in the table below.
Table.3-2-2-A: Models compatible with respective Vertical Flying Cradles
WARNING:
- Be careful not to insert your fingers between the steel arms when you adjust the angle of them.
- Securely fix the bolts for angle adjustiment of the Vertical Flying Cradle except during the installation work.
- Vertical Flying Cradle is not supposed to be used in the following situations, which may cause an injury or
accident.
For all the models, the following situations are quite dangerous.
Suspending from sloped
(non-horizontal) ceiling
Part list (CP-XY1VC1)
Item Part Name
No
Side plate set
1 Side plate (L)
2 Side plate (R)
3 M10 socket head bolt
4 Flat washer
5 Spring washer
Yoke set
6 Yoke
7 M10 socket head bolt
8 Flat washer
9 Spring washer
10 Rubber washer
http://pioneerproaudio.com/
Prohibition of connecting
speakers using
commercially available
eyebolts or CP-XY1CON1
(Only XY-2 available)
Qty Service Note
Part No.
1 -
1 -
1 -
7 - M10 x 40 mm (P=1.5),
8mm hex socket head
7 - M10
7 - M10
1 -
1
7 - M10 x 25 mm (P=1.5),
8mm hex socket head
4 - M10
4 - M10
φ40mm x 2mm
4 -
To the ceiling
NOTE: XY-1 is shown in the illustration.
Prohibited to install
upside down
Required tools
- 8mm hex key
©2020 AlphaTheta CORPORATION
Page 13 / 43