Data Call Commands - Multitech MultiModemISDN MTA128ST-USB User Manual

External isdn terminal adapter
Hide thumbs Also See for MultiModemISDN MTA128ST-USB:
Table of Contents

Advertisement

Data Call Commands

Use these commands to make or configure data calls.
Command: A
Function:
Values:
Default:
Description:Forces TA to answer an incoming call. To make the TA autoanswer, set
Command: D
Function:
Values:
Default:
Description:The D command causes the TA to dial a number (e.g., ATD785-3500 <cr>).
Command: DSn
Function:
Values:
Default:
Description:To dial a stored telephone number, type &DSn in terminal mode, where n is
Command: Hn
Function:
Values:
Default:
Description:Forces TA to go off-hook (to take control of the telephone line) or to go on-
Command: In
Function:
Values:
Default:
Description:Displays the following MTA128ST-USB product information.
Command: O
Function:
Values:
Default:
Description:The O command returns the TA to online mode from online comman mode.
MTA128ST-USB
Chapter 4 - AT Commands, S-Registers and Result Codes
Answer Call
none
none
register S0 to a value higher than 0.
Dial
none
none
Dialing a Stored Telephone Number
n = 0–9
n = 0
the location of the number you want to dial. For example, type ATDS3 <cr>
dials a telephone stored in memory register 3 location.
Hang Up
0
n = 0
hook (hang up). Since the TA goes off-hook automatically when it dials, the H
command is normally used only to hang up. To hang up, first escape to
command mode (+++AT <cr>), then type ATH (or ATH0) <cr>. You also can
include the hang-up command in the escape sequence: +++ATH <cr>.
H
Go on-hook (hang up)
Display Product Information
n = 0, 1, 2, and 4
none
I0
Product ID (e.g., 247)
I1
Firmware version number (e.g. 6.00)
I2
Model number (e.g., MTA128ST-USB)
I4
Date and time firmware was made
Return Online
none
none
When TA makes a data connection, it enters online data mode. TA remains in
this mode until it receives an escape sequence or until the call ends. When it
detects an escape sequence, the TA enters online command mode, where it
can accept AT commands while retaining the online connection. To return TA
to online mode from online command mode, enter ATO and press ENTER.
41

Advertisement

Table of Contents
loading

Table of Contents