Table of Contents
Advertisement
Assembling the MTA128ST-USB
The only assembly required is to mount the feet on the bottom of your unit (See Figure 2-
2). Peel the four self-adhesive plastic feet off the backing strip and press them into the
recesses on the bottom.
Connecting the MTA128ST-USB to Your System
Place the MTA128ST-USB terminal adapter in a convenient location. In a typical
configuration, you will need to connect your MTA128ST-USB to your computer's USB
port, to its own power supply, to the ISDN network terminator, and to any optional analog
equipment you are using (e.g., a telephone). For each cabling procedure, see Figure 2-3.
MTA128ST-USB
Figure 2-2. Mounting the Feet
POWER
USB
PHONE
Figure 2-3. MTA128ST-USB Connections
Chapter 2 - Hardware Installation
ISDN
13
Advertisement
Table of Contents
