Multitech MultiModemISDN MTA128ST-USB User Manual page 50

MultiModemISDN User Guide
Default:
Description:Modifies the value of Octet 3 of the Calling Party Number Information
S-register: S57 (applies to NET3 [!C0=2] switch type only)
Function:
Unit:
Range:
Default:
Description:Modifies the value of Octet 3 of the Called Party Number Information
50
4 Telex
8 National standard
9 Private
128 (disabled)
Element that is sent within the SETUP message for data and POTS port
(voice/modem/fax) calls. To set a specific number type and numbering plan,
select an option from the Type of Number section above and add its value to
the value of an option in the Numbering Plan section above. For example, a
National/ISDN Calling Party Number IE would be S56=33, where 32
(National) + 1 (ISDN/telephony) = 33 (National/ISDN). If there is no Data
Directory Number (for data calls) nor Voice Directory Number (for voice/
modem/fax calls), no Calling Party Number IE is sent. By default S56=128,
which means no Calling Party Number IE is sent.
Called Party Number IE Settings
decimal ASCII code
128 Disable
Type of Number
0 Unknown,
16 International
32 National
48 Network specific
64 Subscriber
96 Abbreviated
Numbering Plan
0 Unknown
1 ISDN/telephony
3 Data
4 Telex
8 National standard
9 Private
128 (disabled)
Element that is sent within the SETUP message for a data call and within
each INFORMATION message that is sent when dialing from the POTS port.
To set a specific number type and numbering plan, select an option from the
Type of Number section above and add its value to the value of an option in
the Numbering Plan section above. For example, a National/ISDN Called
Party Number IE would be S57=33, where 32 (National) + 1 (ISDN/
telephony) = 33 (National/ISDN). By default S57=128, which means no
Called Party Number IE is sent.
MTA128ST-USB