Table of Contents
Advertisement
MultiModemISDN User Guide
Introduction
This chapter details the contents of the MTA128ST-USB shipping container, describes
each cable connection, and describes the LED indicators.
Unpacking Your MTA128ST-USB
The shipping box contains the MTA128ST-USB, an external power supply, one RJ-45
line cord, one RJ-11 phone cord, one USB cable, your Quick Start Guide, and two
diskettes (i.e., the MTA128ST-USB User Guide and the MTA128ST-USB Driver
Software). Inspect the contents for signs of any shipping damage. If damage is
observed, do not power up the unit; contact Multi-Tech's Technical Support for advice
(refer to Chapter 6). If no damage is observed, place the MTA128ST-USB in its final
location and refer to "Connecting the MTA128ST-USB to Your System" in the next
section.
Safety Warning Telecom/ISDN-ST
1. Never install telephone wiring during a lighting storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed
3. This product is to be used with CE approved/marked computers.
4. Never touch uninsulated telephone wires or terminals unless the telephone line has
5. Use caution when installing or modifying telephone lines.
6. Avoid using a telephone (other than a cordless type) during an electrical storm.
7. Do not use the telephone to report a gas leak in the vicinity of the leak.
8. To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line
9. If S/T - interface ISDN network connection cable is used, the ISDN phone cord
12
Four USB V.90 Modems
Quick Start Guide
M AD
Figure 2-1. Unpacking
for wet locations.
been disconnected at the network interface.
There may be a remote risk of electrical shock from lightning.
cord.
should be connected between the ISDN network connection cable and a NT1 device.
U.S .A
MA DE IN
E IN
U. S. A
MTA128ST-USB
Advertisement
Table of Contents
