Table of Contents
Advertisement
MultiModemISDN User Guide
Introduction
This chapter describes how to install the MTA128ST-USB driver software and discusses
how to configure the unit to match your ISDN service and remote terminal adapter (TA).
Driver Software Installation
MTA128ST-USB driver software is installed in Win 98 or Win 95 operating environments.
Installing in Windows 98
1. Power up your Windows 98 system.
2. Turn on your MTA128ST-USB. The LS (Power) LED will light.
3. Plug the "D-shaped" end (Type B) of your USB cable into the USB connector on the
4. Windows will detect that the new modem is present and launch the Add New
5. The Add New Hardware Wizard dialog box is displayed.
18
back of the unit (See Figure 2-3).
Hardware Wizard.
Place the Installation diskette provided with your modem into your floppy drive and
click Next > to proceed with the installation.
Verify that the "Search for the best driver for your device. (Recommended)" option is
selected and click Next >.
MTA128ST-USB
Advertisement
Table of Contents
