Table of Contents
Advertisement
2.2 Intuity System
The Intuity System consists of the
HA7020
WiFi to RFLC Bridge and the
using the
PW1013
2.2.1 Controller
The Legrand
HA7000
installed in the enclosure, and typically powered via the
sheet for the
HA7000
Controller connects with a Cat 5 cable to the security system via the RS232 jack and to the Intercom
system via any one of the Intercom 1-8 jacks. A Cat 5 jumper is used to connect to an Internet
router/switch port via the LAN jack as shown below.
2.2.2 Command Center
The Legrand
HA7110
Automation System. It is a wall-mounted User Interface, located in a convenient area, which
houses the customer supplied iPad Mini. NOTE: Only the iPad Mini 1, 2 and 3 are compatible
with the Legrand HA7110 Command Center. The iPad Mini 4 and other Android tablets are
not able to be mounted into this device.
The instruction sheet supplied with the
instructions The HA7110 Command Center is designed to fit easily into a Pass & Seymour
S352W triple gang old work electrical device box, S354RAC triple gang new work electrical
device box and the AC1010-03 triple gang LV retrofit bracket. It also requires two Cat 5 cables,
plus a 16/2 speaker wire run from the enclosure. The supplied custom USB/audio cable that
will be attached to the iPad Mini before it is installed in the Command Center to power the iPad
HA7000
HA7040
Power Distribution Module and the
Intuity Controller is the heart of the Intuity Home Automation System. It is
Intuity Controller (P/N 1507205) comes with the product. The
Command Center is the primary fixed user-interface for the Intuity Home
HA7110
Intuity Controller, the
WiFi to Z-Wave Bridge. These units can be powered
PW7760
Power Supply.
PW1013
and the PW7760. The installation
(P/N 1507235) outlines physical installation
301 Fulling Mill Road, Suite G
Middletown, PA 17057
5
Page
(800) 321-2343
HA7110
Command Center, the
HA7000
©Copyright 2015 by Legrand,
Inc All Rights Reserved.
www.legrand.us
Intuity
Advertisement
Table of Contents
