legrand radiant Manual

Before you start

Review this guide in its entirety. Consult an electrician with any questions or if you are unsure of your abilities.

To reduce the risk of injury and/or overheating and damage to other equipment:

• For dry, indoor use only.
• Connect the Smart Plug-In Switch to a 120 VAC, 60 Hz power source ONLY.
• To reduce the risk of electrical shock, this equipment has a grounding type plug that has a third (grounding) pin. If the plug does not fit in outlet, contact a qualified electrician to install the proper outlet. specifications

Specifications

Legrand reserves the right to change specifications without notice.
Visit www.legrand.us/radiant/smart-lighting/support for support.

Installation & setup

1. Plug in the smart plug-in switch
   Insert the lamp or device to be controlled into the outlet on the Smart Plug-In Switch.
   
2. Test the smart plug-in switch
   1. With the lamp or device on, press the button on the Legrand Smart Plug-In Switch to turn your device on.
   2. Press the button to turn your device off.
      TROUBLESHOOTING TIP:
      If the device is not responding to the switch, confirm that the outlet is powered and that the device is functional.
3. Set up your Matter-compatible plug-in
   This product is Matter-certified and designed to be used with a Mattercompliant smart home platform (Amazon Alexa, Google Home, Apple Home, Samsung SmartThings, etc.)
   1. A Matter-compliant controller (Home Hub / Admin) and smart home app of the same platform is required for setup.
   2. Turn on Bluetooth and connect to a 2.4 GHz Wi-Fi network on your smartphone (5 GHz networks not supported)
   3. Open your Matter-complaint smart home app and follow the in-app instructions for adding a Matter device.

TROULBESHOOTING:
If the plug-in is not appearing during setup or fails during the setup process, confirm that the device is powered and perform the factory reset procedure. Once the device has been reset, restart the setup process in your smart home app.

MULTIPLE PLATFORMS:
If wanting to provide access across multiple smart home platforms, the initial QR code on the device will only work with the first app that was used. To setup in subsequent apps and systems, a new Matter code will need to be generated in the original app the device was setup with.

QUICK SETUP TIP:
For an even faster setup process, open the Camera app on your phone and scan the QR code on the back of the device. This will set the plug device up in your preferred Matter-compatible smart home platform.

Getting to know your plug-in

LED LOCATOR LIGHT EXPLANATIONS

LED Color	State of Light	Explanation
	Blinking Green	Factory default; ready to connect to your network.
	Solid Green	Device is connected to your network.

RESET TO FACTORY DEFAULT
You can reset the device to the factory settings by holding down the power button for 10 seconds until the LED blinks red and green.

www.legrand.us