Adding A Wifi To Z-Wave Bridge; Access Website And Provision Bridge - LEGRAND Intuity Home Automation System Installation Manual

6.2 Adding a WiFi to Z-Wave Bridge

The WiFi to Z-Wave Bridge will act as a
WiFi Hotspot when first connected to
power. Its SSID is Legrand Bridge XXXX
(XXXX are the last 4 digits of its MAC
address which can be found on the label
on the back of the unit). The top LED is
the power LED and will be on solid (white)
when power is applied. The middle LED is
WiFi, and it should be blinking slowly at
this point. The bottom LED is the Hub LED
and will be off at this point.

6.2.1 Access Website and Provision Bridge

Step 1 – Connect the Tablet/Laptop to the home's WiFi network (Internet access is required).
Step 2 – Open a browser on the Tablet/Laptop (Safari/Chrome) and go to
intuity.legrand.us/provisioning.
Step 3 – Enter the User name ("installer") and the password as ("PASSWORD").
Step 4 – Save the webpage (example screen shown below) as a Home Screen link on the
Tablet/Laptop (or bookmark the link via the browser). This will make for easy access to this page for
future WiFi Bridge installations.
Step 4a - Move the Tablet/Laptop within 10' of the Bridge.
301 Fulling Mill Road, Suite G
Middletown, PA 17057
26
Page
(800) 321-2343
Power
WiFi
Hub
©Copyright 2015 by Legrand,
Inc All Rights Reserved.
www.legrand.us