Table of Contents
Advertisement
Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable
Figure 10
Adjusting the
Motion-Control Levers
Adjusting the Height
You can adjust the motion-control levers higher or
lower for maximum comfort
(Figure
10).
(Figure
11).
Figure 11
Adjusting the Tilt
You can adjust the motion-control levers forward or
rearward for your comfort.
1.
Loosen the upper bolt holding the control lever
to the control-arm shaft.
2.
Loosen the lower bolt just enough to pivot the
control lever forward or rearward
3.
Tighten both bolts to secure the control lever in
the new position.
4.
Repeat the adjustment for the other control lever.
During Operation
During Operation Safety
General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; slip-resistant, substantial footwear; and
hearing protection. Tie back long hair and do not
g027249
wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Avoid mowing on wet grass. Reduced traction
could cause the machine to slide.
•
Ensure that all drives are in neutral, the parking
brake is engaged, and you are in the operating
position before you start the engine.
•
Keep your hands and feet away from the cutting
units. Keep clear of the discharge opening at all
times.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Do not mow near drop-offs, ditches, or
embankments. The machine could suddenly roll
over if a wheel goes over the edge or if the edge
g027252
gives way.
•
Stop the blades whenever you are not mowing.
•
Stop the machine and inspect the blades after
striking an object or if there is an abnormal
16
(Figure
11).
Advertisement
Table of Contents
