Room Cutoff - NEC NEAX2400 IMX Features Manual

R-9
General Description
This feature allows the Console, PMS terminal, or Front Desk Terminal to temporarily restrict outgoing CO calls
from guest room telephones while the guests are away.
Operating Procedure
To set ROOM CUTOFF from Console or Front Desk Terminal:
•
Step Action
1 Press the RCS (set) key.
2 Dial the station number.
3 Press the ENTER key.
4 Press the EXIT key.
Note:
If the "RC" steady display is available by system data, the following will display on a Guest station D
To cancel ROOM CUTOFF from the Console or Front Desk Terminal:
•
Step Action
1 Press the RCR (reset) key.
2 Dial the station number.
3 Press the ENTER key.
4 Press the EXIT key.
term
Note:
If a D is used for a guest station, the "RC" display (if provided) will go out.
To obtain a printout of stations in ROOM CUTOFF mode, refer to the AUDIT REPORTS [A-26] feature
description.
Note 1: If an error is made in the course of key operations, press the CLEAR key and continue from Step 2 (station dialing).
Note 2: When setting or canceling ROOM CUTOFF for two or more stations at the same time, follow the above operating
procedure for the first station. Perform Steps 2 and 3 for the remaining stations, then perform Step 4 to exit from the
service mode.
Note 3: DIRECT SERVICE SET/RESET [D-25] is available for this feature. Refer to the feature description for details.
NEAX2400 IMX Hotel Features and Specifications
NDA-24245, Issue 2

Room Cutoff

Room Cutoff
The associated lamp illuminates.
The console displays the station number.
The lamp flashes to confirm that ROOM CUTOFF is set.
The lamp and station display are extinguished.
RC
(Time and Date)
The associated lamp illuminates.
The console displays the station number.
The lamp flashes to confirm that ROOM CUTOFF is set.
The lamp and station display are extinguished (ROOM CUTOFF
status is automatically cancelled when CHECK-IN is initiated from
the Console or PMS terminal).
(Time and Date)
Result
>>>
Result
>>>
R-9
(Note)
term
:
(Note)
Page 121