Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual page 8

ED5200N Series Exit Devices
3. Install Outside Trim
a. Make sure tailpiece is oriented vertically.
b. Feed trim wire harness through wire harness hole (Fig. 3a).
c. Mount trim assembly to door pulling slack wire towards device side of door.
Note: Be careful not to pinch wire harness.
d. When mounting trim, lift tailpiece to pass through hole on device side.
Note: Make sure tailpiece is still oriented vertically.
e. Fasten trim assembly to door using (2) 1/4-20 oval head screws and (2) finish washers (Fig. 3b).
Note: Finger tighten only.
Trim
Wire Harness
and Ground
Tailpiece must be
in vertical position
Fig. 3a
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
7) Installation Instructions (Continued)
b
Wire
Harness
b
Hole
8
b
Fig. 3b