Table Of Contents; Warning - Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual

Exit devices for 9600 tcrne1 series trims m812 - iclass se reader option

Hide thumbs Also See for Corbin Russwin ED5200N Series:

Installation instructions manual (28 pages)

Installation instructions manual (20 pages)

Installation instructions manual (31 pages)

Table Of Contents

Table of Contents

ED5200N Series Exit Devices

1) Warning ............................................................................................ 2

2) General Description ......................................................................... 3

3) Features ........................................................................................... 3

4) Regulatory Specifications ............................................................... 3

5) Wiring Diagrams .............................................................................. 4

6) Product Illustrations ........................................................................ 6

7) Installation Instructions .................................................................. 7

8) Surface Vertical Rod Installation Instructions ............................. 14

9) Operational Check ......................................................................... 18

Warning: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equip-

ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

• Consult the dealer or an experienced technician for help

Contains FCC ID: U4A-SCSEHF

Contains IC: 6982A-SCSEHF

The term "IC:" before the radio certification number only signifies that Industry Canada technical specifications were met. This Class B digital

apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interfer-

ence that may cause undesired operation.

Cet appareillage numérique de la classe B répond à toutes les exigences de l'interférence canadienne causant des règlements

d'équipement. L'opération est sujette aux deux conditions suivantes: (1) ce dispositif peut ne pas causer l'interférence nocive, et (2) ce dis-

positif doit accepter n'importe quelle interférence reçue, y compris l'interférence qui peut causer l'opération peu désirée.

To avoid possible damage from electrostatic discharge (ESD), some basic precautions should be used when handling electronic components:

• Minimize build-up of static by touching and/or maintaining contact with unpainted metal surfaces such as door hinges, latches and mounting

plates especially when mounting electronic components such as readers and controllers onto the door.

• Leave components (reader and controller) protected in their respective anti-static bags until ready for installation

• Do not touch pins, leads or solder connections on the circuit boards

*Any retrofit or other field modification to a fire rated opening can potentially impact the fire rating of the opening, and Corbin Russwin, Inc. makes no representa-

tions or warranties concerning what such impact may be in any specific situation. When retrofitting any portion of an existing fire rated opening, or specifying and

installing a new fire-rated opening, please consult with a code specialist or local code official (Authority Having Jurisdiction) to ensure compliance with all applicable

codes and ratings.

express written permission of Corbin Russwin, Inc. is prohibited.