Table of Contents
Advertisement
MP9800 Series
Access 600 Integrated Wiegand
with and without MELR Option (Electric Latch Retraction)
Multi-Point Lock
Installation Instructions
11
Installation
A. Prepare door.
1. Verify hand and bevel of door. (Figure 1)
• Check hand of door. Multi-point lock may
be handed.
• Door should be fitted and hung.
• Verify box label for size of multi-point
lock, function and hand.
Note: MP9800 locks with Access 600 are
handed and NOT field reversible.
2. Prepare door.
If door is not pre-drilled, prepare door
according to appropriate template. Refer
to templates at corbinrusswin.com.
(Figure 2)
• Metal door (Steel & MPAD): FM438
- Templates: T31242
• Wood door (MPWD): FM436
- Templates: T31243
Note: For MELR door prep see Step F and
use plastic template.
B. Install rod and top case.
1. Refer to instruction sheet FM438 for
rod and inner case installation on metal
doors.
2. Refer to instruction sheet FM436 for
rod and inner case installation on wood
doors. (Figure 3)
C. Install outside and inside trim.
1. Outside Trim
• For exterior applications, use gasket
(765F859) to seal escutcheon and
outside door surface. (Figure 4)
• Feed wire through hole and attach
outside exit trim to door.
2. Inside Trim
• Position trim carefully onto inside of door.
Be careful not to pinch wire harness.
• Mount inside trim lever using two (2)
#1/4"-20 x 3" Phillips oval head machine
screws. (Figure 5)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Left Hand
Reverse
LHR
Figure 1
Access 600
Outside
Figure 2
Figure 4
11
Inside
Right Hand
Reverse
RHR
Outside
Inside
Outside
Figure 3
Figure 5
Outside
Exit Trim
Inside
Exit Trim
FM437 11/18
Advertisement
Table of Contents
