Assa Abloy Corbin Russwin MP9800 Series Installation Instructions Manual page 15

MP9800 Series
Access 600 Integrated Wiegand
with and without MELR Option (Electric Latch Retraction)
Multi-Point Lock
Installation Instructions
11 Installation continued
NOTE: If installing an Access 600 x M812
proceed to step K.
J. Position inside escutcheon and wires.
(For Access 600 x M802)
NOTE: Follow these steps prior to installing
inside escutcheon assembly to prevent any
damage caused by pinching wires.
1. Align ElectroLynx® connectors (8 and 4-pin)
to one side of wire guide inside of door.
Reader connections and excess wire are
arranged on other side.
2. Connect ElectroLynx® connectors (8 and
4-pin) and establish their position inside of
door on proper side of wire guide. (Figure 17)
3. Neatly route remaining wires onto themselves
and into remaining space to prevent pinching
wires when mounting escutcheon. (Figure 18)
Note: To complete installation of Access 600
M802, proceed to step N.
K. Connect ElectroLynx harness.
(For Access 600 x M812)
NOTE: Follow these steps prior to installing
inside escutcheon assembly to prevent any
damage caused by pinching wires.
1. Feed controller harness earth ground into
and around behind rim of large upper hole of
mounting plate. (Figure 19)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure 17
Figure 18
J5
Controller
PCB
15
Inside of
Door
Earth
ground
Figure 19
FM437 11/18