Table of Contents
Advertisement
MP9800 Series
Access 600 Integrated Wiegand
with and without MELR Option (Electric Latch Retraction)
Multi-Point Lock
Installation Instructions
11
Installation continued
3. Twist into place, perpendicular with
door. (Figure 22)
4. Position green/yellow ground wire ring
terminal (from lockbody) over hole for
top left screw. (Figure 22)
5. Position green/yellow reader harness
earth ground on top of ground ring
and thread both with one (1) 8-32 x
3/8" Phillips flat head undercut combo
screw. (Figure 23)
IMPORTANT: Note orientation of
ground ring terminals.
6. Tighten securely.
Connector Attachment
(Exterior PCB Assembly)
1. Connect P3 (2-pin connector) from
lockbody to J3 on module. (Figure 24)
2. Connect P4 (6-pin connector) from
lockbody to J4 on module. (Figure 24)
N. Position inside escutcheon and wires.
(MELR) M802 or M812
1. Position escutcheon against door by
hooking top edge on top of MELR
assembly. Verify that no wires are
being pinched.
2. Mount inside escutcheon assembly
to plate using one (1) #8-32 x 5/8"
Phillips flat head undercut machine
screw. (Figure 25)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure 23
M802 MELR
17
Inside of
Door
8-32 x 3/8"
Phillips Flat Head
Undercut Combo
Screw
Figure 22
P3
Figure 24
M812 MELR
Figure 25
FM437 11/18
P4
Advertisement
Table of Contents
