The Lcd Display - KStar YDC9300-B Operation Manual

CAUTION!
Parallel cable cannot be connected when setting the parallel parameters.
◆After setting the UPS needed to be paralleled, power off all the UPS. Connect all the UPS
according to "parallel cable installation", and then power on the UPS .

4.3 The LCD Display

(1)LED indicator (2)LCD display (3)Scroll button: enter to next item (4)Off button (5)On button
Introduction
CAUTION!
The display provides more functions than those
described in this manual.
There are 12 interfaces available in the LCD display:
Item Interface Description
01
02 Input A(Input L1)
03 Input B(Input L2)
04 Input C(Input L3)
05
06
07
08
09
10
11 Software version & model
12
Overview of the operating panel of the UPS
CODE
Bat. +
Bat. -
Backup time
Output
Load
Temperature
CODE
Content Displayed
Operational status and mode
Voltage & Frequency
Voltage & Frequency
Voltage & Frequency
Voltage & Current
Voltage & Current
Capacity & Time
Voltage & Frequency
battery temperature(need to connect batter
sensor, Internal temperature and ambient
temperature
Version of rectifier software, version of inverter
software, model
Alarm Code(Warming Message)
22
Load