KStar YDC9300-B Operation Manual page 28

4.4.1 Mode setting
Mode setting (Note: Inside the broken-line is the flashing part.)
After entering the setting menu, its mode setting defaulted, and the mode setting line flashing as
in above picture. ①Use button "" to choose different mode. There are 3 different modes for setting:
ECO, PAL, NOR. ②Press "ON" to exit the mode setting and save the mode setting value, and goes
to output voltage setting. ③Press "OFF" to exit the mode setting, and goes to parallel redundancy
quantity setting.
4.4.2 Output voltage setting
Output voltage setting (Note: Inside the broken-line is the flashing part.)
In the mode setting press "ON" or in frequency setting press "Off", it goes to the output voltage
setting. The output voltage line flashes as in above picture. ①Use button "" to choose the different
output voltage. There are 3 different voltages---220, 230, 240. ②Press "ON" to exit the output
voltage setting and save the output voltage setting value, and goes to frequency setting. ③Press
"OFF" to exit the output voltage setting, and goes to mode setting.
CAUTION!
When powered by inverter, it is necessary to turn off the inverter
before setting voltage and frequency level.
26