Options - KStar YDC9300-B Operation Manual

15 DC Bus over voltage
16 DC Bus below voltage
17 DC bus unbalance
18 Soft start failed
19 Rectifier Over Temperature
20 Inverter Over temperature
21 Input neutral loss
22 Battery reverse
23 Cable connection error
24 CAN comm. Fault
25 Parallel load sharing fault
26 Battery over voltage
27 Reserve
28 Reserve
29 Output Short-circuit
30 Rectifier over current
31 Bypass over current
32 Overload
33 No battery
34 Battery under voltage
35 Battery low pre-warning
36 Internal Communication Error
37 DC component over limit.
38 Parallel Overload
39 Mains volt. Abnormal
40 Mains freq. abnormal
41 Bypass Not Available
42 Bypass unable to trace
43 Inverter on invalid
44 Reserve
45 inverter not on

4.7 Options

SNMP card: internal SNMP / external SNMP optional
◆ Loosen the 2 torque screws (on each side of the card).
◆ Carefully pull out the card. Reverse the procedure for re-installation
The slot called SNMP supports the MEGAtec protocol. We advise that NetAgent II-3 port is also
a tool to remotely monitor and manage any UPS system
Beep continuously
Beep continuously
Beep continuously
Beep continuously
Twice per second
Twice per second
Twice per second
Twice per second
Twice per second
Twice per second
Twice per second
Once per second
Once per second
Once per second
Once per second
Once per second
Once per second
Once per second
Once per second
Once per second
Once per second
Once per 2 seconds
Once per 2 seconds
Once per 2 seconds
Once per 2 seconds
Once per 2 seconds
35
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED lit
Fault LED blinking
Fault LED blinking
Fault LED blinking
Fault LED blinking
Fault LED blinking
BPS LED blinking
INV or BPS LED blinking
Battery LED blinking
Battery LED blinking
Battery LED blinking
Fault LED blinking
INV LED blinking
INV LED blinking
Battery LED lit
Battery LED lit
BPS LED blinking
BPS LED blinking