Bios Configuration; Starting The Bios System Configuration Utility; Viewing System Information - Oracle MICROS 6 Series Setup Manual

9

BIOS Configuration

This section describes how to enter the BIOS System Configuration Utility and how to
configure the system BIOS.
The Oracle MICROS Workstation 625/655 ships with the BIOS pre-configured for
optimal performance. In most cases you will not need to change settings.
•

Starting the BIOS System Configuration Utility

•

Viewing System Information

• Configuring Workstation Settings
• Configuring System Security Settings
• Configuring the Boot Priority for Devices
• Exiting the BIOS Configuration Utility
Starting the BIOS System Configuration Utility
To configure the BIOS, start the BIOS System Configuration Utility using the following
steps:
Connect a USB keyboard to the Workstation 6.
1.
Power on or restart the workstation.
2.
Press F2 immediately after pressing the power button or tap the left or right third of
3.
the bootup screen to enter the BIOS Configuration Utility.
If the workstation boots into the operating system without starting the utility, restart
the workstation and try again.
Viewing System Information
On the BIOS Home screen, tap Main, and then tap System Information.
The following is an example set of information presented by the BIOS system
information screen. The actual data shown by your system may vary:
• BIOS Version: 0.0.0.P.404 X64
• Build Time: 02/06/2020
• SMBIOS Version: 03.01
• Processor Type: Intel(R) Celeron(R) CPU 4305UE @ 2.00GHz
• Processor Speed: 2.000 GHz
• System Memory Speed: 2133 MHz
• L2 Cache RAM: 512 KB
• Total Memory: 8192 MB
9-1