Oki MC362w Maintenance Manual page 238

Oki Data CONFIDENTIAL
Display Cause
Inspection is Option unit I/F
required. error
182 : Error Does the error occur again?
Does the error occur again?
Power OFF/ON System
190 : Error memory
overflow Does the error occur again?
Inspection is PU firmware An error occurred in re-
required. download error writing
200 : Error the PU firmware.
～
202 : Error
Power OFF/ON CU program Invalid processing was
203 : Error error (203 performed with a CU
204 : Error to 214 do program.
207 : Error not occur in
208 : Error general use of
213 : Error the MFP)
214 : Error
F0C : Error
FFE : Error
FFF : Error
Power OFF/ON Custom Custom Media Type table
209 : Download Media downloading failed.
error Type table
downloading
failure
44952001TH Rev.2
Error details Measure
Turn off and on the
MFP.
Yes Be sure of connector
connection.
Yes Replace the option
unit.
Turn off and on the
MFP.
Yes Replace the CU/PU
board.
Turn off and on the
MFP, and then re-
download it (In general
use of the MFP, this
re-writing is not
performed and this
error does not occur).
Replace the CU/PU
board.
Turn off and on the
MFP, and then re-
download it (In general
use of the MFP, this
downloading is not
performed and this
error does not occur).
Display Cause
Inspection is TAG interface IA TAG interface error was
required. error detected.
231 : Error *
01 : A short-circuit error.
03 : TAG communication
error.
Power OFF/ON SD card error
250 : Error
Inspection is SD card
required. erasure error
251 : Error
Inspection is SD card
required. security error
252 : Error
～
255 : Error
Inspection is SD card error
required.
256 : Error
257 : Error
Power OFF/ON SU Exception Does the error occur again?
Error : 802
Error : 803
Error : 805
Error : 807
Error : 808
Power OFF/ON SU NAND The ECC error that
Error : 809 ECC Error restoration was impossible
occurred in NAND FLASH of
SU.
Power OFF/ON SU Com- Communication error
Error : 811 munication between the Controller and
Error : 812 Error the Scanner Unit is detected.
Error : 813
7. TROUBLESHOOTING PROCEDURES
Error details Measure
Be sure the toner
cartridges and the
image drums are
properly set.
Replace the toner
cartridges. When the
error occurs again
after the image drums
are re-installed, be
sure of the cable
connection from the
CU/PU board to the
toner sensor board.
Yes Turn off and on the
MFP.
Replace the SU board.
Turn off and on the
MFP.
7-46