Oki MC362w Maintenance Manual page 181

Oki Data CONFIDENTIAL
(2) [When not facing OEL]
(2-1) Set the PU serial number
(Maintenance utility operation manual, Section 2.4.1.2, PU circuit
board setting) SAP serial number can be applied to the device. The
SAP serial number is displayed in the highest rung of the serial
number label. It is a 12-digit number including production place (2
digits), production year (2 digits), sequence number (6 digits) and
revision number (2 digits).
• PU serial number is a 10-digit number which is basically the same
as SAP serial number except that it has no the 2-digit revision
number.
• Set on the menu of [Section 2.4.1.1.2.1, PU serial number setting]
of [Section 2.4.1.1.2 PU circuit board setting function].
• If you want to specify the PU serial number, please add a "0" (a
normal-width zero) then input the 11-digit number. (Please notice
that when read out, the number will be 10 digits.)
As shown in the following image, on the menu of [PU serial
number setting], eliminate the 2-digit revision number then add a
normal-width zero to the 10-digit number and input it.
Add one-byte 0 to the top of 10-digit figure of 12-digit SAP serial number to set.
Set "0AE01234567" in the setting screen of PU serial number.
A E 0 1 2 3 4 5 6 7 8 9
Figure of Serial No. label image
• PU serial number will be output to the Printer Serial Number
column in the header of Status Page. For this reason, check of PU
serial number is performed by printing
Status Page.
• After the configuration in the UK factory, when facing OEL, the
PU serial number is taken as Lot Number and shown in the Lot
Number: column of the last line which is in the header of the
Status Page.
44952001TH Rev.2
Revision
A B Made in C
(2-2) Set the CU serial number
CU serial numbe setting is unnecessary When not facing OEL.
(3) Change to Shipping mode (section 2.4.1.1.10.4 of Maintenance Utility
Operating Manual)
The printer is placed in the Factory mode after the CU/PU board is replaced with
a new one. Switch the printer to the Shipping mode.
• Use the window for the Factory/Shipping mode described section 2.4.1.1.10.4
in Maintenance Utility section 2.4.1.1.10 about board setting functionality
Note! Note that replacing the EEPROM (the engine control board) clears life
information about units, including the belt, toner and image drums, causing
errors in managing the lives of the units until the units are replaced. Below is
the counts cleared with such CU/PU board replacement. When the units are
replaced with new ones, their respective counts except for Total Sheets Fed
are cleared, the errors being corrected.
Item Description
Fuser unit A fuser life count.
Belt unit A belt unit life count.
Image drum unit Each the image drum
unit life count for a color.
Total number of sheets A printer life count.
Print black Each the number of
Print yellow pages printed with an
Print magenta image drum.
Print cyan
5. MAINTENANCE MENUS
Count description
A value converted on an A4
page basis from the number
of pages printed to date after
installation of a new fuser unit.
A value converted on an A4
page basis from the number
of pages printed to date after
installation of a new belt unit.
A value converted on an A4
page basis from the number
of pages printed to date after
installation of a new image drum
unit.
The total number of sheets fed.
The number of pages printed
after installation of a new image
drum unit.
5-34